U.S. flag

An official website of the United States government, Department of Justice.

Firearms Examiner Training

AFTE Range of Conclusions

Home  |  Glossary  |  Resources  |  Help  |  Contact Us  |  Course Map
 

AFTE Range of Conclusions

Based on the AFTE Theory of Identification, there are four categories of examination outcomes (AFTE Range of Conclusions Possible When Comparing Toolmarks) typically used by firearm examiners in the microscopic comparison of fired bullets. Laboratory protocols determine how final conclusions are reported.

The following categories are accepted for all types of toolmark comparisons:

  • Identification
  • Inconclusive
  • Elimination
  • Unsuitable for comparison

Identification

Identification of two copper jacketed bullets
Identification of two copper jacketed bullets
Courtesy of Jack Dillon (see reuse policy).

The AFTE Glossary defines identification as:

"Agreement of a combination of individual characteristics and all discernable class characteristics where the extent of agreement exceeds that which can occur in the comparison of toolmarks made by different tools and is consistent with the agreement demonstrated by toolmarks known to have been produced by the same tool."

This statement reflects the concepts of sufficient agreement and best known nonmatch. All identifications are based on pattern matching. It is possible to go beyond this qualitative match to the quantifiable consecutive matching striae (CMS) approach to further support an identification.

Inconclusive

Agreement of class characteristics
Agreement of class characteristics
Courtesy of Bill Conrad (see reuse policy).

An inconclusive result is defined as the outcome of a comparison in which there is

  • some agreement of individual characteristics and all discernable class characteristics, but insufficient for identification,
  • agreement of all discernable class characteristics without agreement or disagreement of individual characteristics due to an absence, insufficiency, or lack of reproducibility,
  • agreement of all discernable class characteristics and disagreement of individual characteristics, but insufficient for an elimination.

Elimination

As defined in the AFTE Glossary, elimination is a significant disagreement of discernable class characteristics and/or individual characteristics. For fired bullet comparisons, an elimination is normally based on observed differences in any one of the general rifling characteristics.

However, an elimination based on individual characteristics is more complex. If it can be shown that a firearm has not been subjected to significant use or abuse over the period of time following the questioned shooting, the qualitative aspects of the striations (e.g., fineness, coarseness) it produces on fired bullets should remain the same. A difference in these striations indicates an elimination.

Elimination based on individual characteristics requires a detailed knowledge of the history and treatment of the firearm, as well as documentation to support the history. It is the responsibility of the examiner to provide this historical documentation. This type of elimination should be approached with caution. Many experienced examiners have never made such an elimination and the protocols of many laboratories do not allow it.

 

Unsuitable

Lack of marks on a bullet fired through an inappropriate or low-quality firearm
Lack of marks on a bullet fired through an inappropriate or low-quality firearm
Courtesy of Jack Dillon (see reuse policy).

Fired bullets in this category are determined to be unsuitable for comparison.

This outcome is appropriate for fired bullet fragments that do not bear microscopic marks of value for comparison purposes.

These may be

  • fired bullet fragments,
  • jacket fragments,
  • lead bullet cores,
  • lead fragments,
  • other portions of fragmented, mutilated, or otherwise damaged bullets
  • metallic fragments that cannot be identified as having been a part of a fired bullet (often the product of crime scene searches where all small metal items were collected).

Back Forward