U.S. flag

An official website of the United States government, Department of Justice.

Firearms Examiner Training

Damaged Bullets

Home  |  Glossary  |  Resources  |  Help  |  Contact Us  |  Course Map
 

Damaged Bullets

In some cases, bullets bear no microscopic marks of value for comparison purposes because they are fragmented, distorted, deformed, or otherwise damaged.

There may be retrievable information if all of the following are present:

  • One or more measurable land impression
  • One or more measurable groove impression
  • Sufficient bullet remains to determine a measured caliber

Used with caution in selected cases, this information may allow a calculation of the number of land and groove impressions present prior to the damage.

If information exists to perform the calculation and if direction of twist can be determined, then sufficient information is available to search the GRC file for possible firearms that could have fired the bullet.

The formula for the calculation is as follows:
Number of lands and grooves = multiply the estimated caliber by 'pi' and divide that product by LWD plus GWD

Applied to 9mm Luger bullet where:

  • Estimated caliber = 0.355 inches
  • = 3.1416
  • Land width dimension (LWD) = 0.069 inches
  • Groove width dimension (GWD) = 0.115 inches

 

Number of lands and grooves = .355 * 3.1416 all divided by the summation of .069 plus .115

                                             = 1,115 divided by .184

                                             = 6.06, or 6

 

Microscopic Marks

The greatest potential for obtaining forensic information from fired bullets is found within the land and groove impressions in the form of microscopic striations.

The information obtained from these striations goes beyond class characteristics (GRC) and is

  • unique to a particular firearm,
  • reproducible shot after shot,
  • identifiable with a specific firearm.

If microscopic marks are present, they must be evaluated for their potential; this information should be noted in the worksheet and related report.

There are three possibilities resulting from the evaluation of microscopic marks on fired bullets:

  • Microscopic marks are present and sufficient for comparison purposes.
  • Microscopic marks are present, but insufficient for comparison purposes.
  • Microscopic marks are not present, precluding an identification.

Rifling Impressions

 

Hammer forged 6-right polygonal rifling pattern
Hammer forged 6-right polygonal rifling pattern
Courtesy of FirearmsID.com (see reuse policy).

Polygonal rifling prohibits the examiner from measuring the width of land and groove impressions because the lands and grooves have a rounded profile instead of a well-defined rectangular profile.

Polygonal rifling is most frequently observed in firearms marketed by Glock and Heckler & Koch. In the FBI GRC file, the land and groove widths for these firearms are listed as 0.000.

Firing a cartridge in an inappropriate firearm with a barrel of a larger diameter than the bullet may leave no rifling impressions on the bearing surface of a bullet.

   

 

Adapter
Adapter
Courtesy of Jack Dillon (see reuse policy).

An adapter (subcaliber device) is an auxiliary chamber inserted into the chamber of a firearm, allowing the firing of smaller diameter or lower power ammunition. Adapters may or may not be rifled. If rifled, the impressions would originate from the adapter, not the firearm. Several adapters are listed in the GRC file.

Back Forward